Dielectric Properties of 3D Printed Polylactic Acid
2017
3D printers constitute a fast-growing worldwide market. These printers are often employed in research and development fields related to engineering or architecture, especially for structural components or rapid prototyping. Recently, there is enormous progress in available materials for enhanced printing systems that allow additive manufacturing of
complex functionalproducts, like batteries or electronics. The polymer
polylactic acid(PLA) plays an important role in
fused filament fabrication, a technique used for commercially available low-budget 3D printers. This printing technology is an economical tool for the development of functional components or cases for electronics, for example, for lab purposes. Here we investigate if the material properties of “as-printed” PLA, which was fabricated by a commercially available 3D printer, are suitable to be used in electrical measurement setups or even as a functional material itself in electronic devices. For this reason, we conduct differential scanning calorimetry measurements and a thorough temperature and frequency-
dependent analysisof its dielectric properties. These results are compared to partially crystalline and completely amorphous PLA, indicating that the dielectric properties of “as-printed” PLA are similar to the latter. Finally, we demonstrate that the conductivity of PLA can be enhanced by mixing it with the ionic liquid “trihexyl tetradecyl
phosphonium
decanoate.” This provides a route to tailor PLA for
complex functionalproducts produced by an economical
fused filament fabrication.
Keywords:
-
Correction
-
Source
-
Cite
-
Save
41
References
40
Citations
NaN
KQI