YANG Data Model for requesting Path Computation
2021
There are scenarios, typically in a hierarchical Software-Defined
Networking (SDN) context, where the topology information provided by a
Traffic Engineering (TE) network provider may not be sufficient for
its client to perform end-to-end path computation. In these cases the
client would need to request the provider to calculate some (partial)
feasible paths. This document defines a YANG data model for a Remote
Procedure Call (RPC) to request path computation. This model
complements the solution, defined in RFCXXXX, to configure a TE tunnel
path in "compute-only" mode. [RFC EDITOR NOTE: Please replace RFC
XXXX with the RFC number of draft-ietf-teas-yang-te once it has been
published. Moreover this document describes some use cases where a
path computation request, via YANG-based protocols (e.g., NETCONF or
RESTCONF), can be needed.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
0
References
0
Citations
NaN
KQI