Time-Multiplexed Illumination for simultaneous Structural and Functional Voltage Sensitive Dye Recordings with a single Photo Sensor

The in-vivo optical imaging of the cortical surface provides the ability to record different types of biophysiological signals, e.g., structural information, intrinsic signals, like blood oxygenation coupled reflection changes as well as extrinsic properties of voltage sensitive probes, like fluorescent voltage-sensitive dyes. The recorded data sets have very high temporal and spatial resolutions on a meso– to macroscopic scale, which surpass conventional multi-electrode recordings. Both, intrinsic and functional data sets, each provide unique information about temporal and spatial dynamics of cortical functioning, yet have individual drawbacks. To optimize the informational value it would thus be opportune to combine different types of optical imaging in a near simultaneous recording.Due to the low signal-to-noise ratio of voltage-sensitive dyes it is necessary to reduce stray light pollution below the level of the camera’s dark noise. It is thus impossible to record full-spectrum optical data sets. We address this problem by a time-multiplexed illumination, bespoke to the utilized voltage sensitive dye, to record an alternating series of intrinsic and extrinsic frames by a high-frequency CMOS sensor. These near simultaneous data series can be used to compare the mutual influence of intrinsic and extrinsic dynamics (with regards to extracorporeal functional imaging) as well as for motion compensation and thus for minimizing frame averaging, which in turn results in increased spatial precision of functional data and in a reduction of necessary experimental data sets (3R principle).