Directed self-assembly of spheroids into modular vascular beds for engineering large tissue constructs.

Spheroids can be used as building-blocks for bottom-up generation of artificial vascular beds, but current biofabrication strategies are often time-consuming and complex. Also, pre-optimization of single spheroid properties is often neglected. Here, we report a simple setup for rapid biomanufacturing of spheroid-based patch-like vascular beds. Prior to patch assembly, spheroids combining mesenchymal stem/stromal cells (MSC) and outgrowth endothelial cells (OEC) at different ratios (10:1; 5:1; 1:1; 1:5) were formed in non-adhesive microwells and monitored along 7 days. Optimal OEC retention and organization was observed at 1:1 MSC/OEC ratio. Dynamic remodelling of spheroids led to changes in both cellular and extracellular matrix components (ECM) over time. Some OEC formed internal clusters, while others organized into a peripheral monolayer, stabilized by ECM and pericyte-like cells, with concomitant increase in surface stiffness. Along spheroid culture, OEC switched from an active to a quiescent state, and their endothelial sprouting potential was significantly abrogated, suggesting that immature spheroids may be more therapeutically relevant. Non-adhesive moulds were subsequently used for triggering rapid, one-step, spheroid formation/fusion into square-shaped patches, with spheroids uniformly interspaced via a thin cell layer. The high surface area, endothelial sprouting potential, and scalability of the developed spheroid-based patches make them stand out as artificial vascular beds for modular engineering of large tissue constructs.